VOLVO TRUCK FL MK I 220 6.6L 162kW/217HP LUCAS

ECU LUCAS PLCC 28HC256 · 220 CV (162 kW) · 6600 cc · Diesel sovralimentato

ECU-databaseVOLVO TRUCK › VOLVO TRUCK FL MK I 220 6.6L 162kW/217HP LUCAS

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 13 firmwareversies

Voertuiggegevens

MerkVOLVO TRUCK
ModelFL MK I
Motor220 6.6L 162kW/217HP LUCAS
Standaard vermogen220 CV / 162 kW
Cilinderinhoud6600 cc
BrandstofDiesel sovralimentato
VoertuigtypeTir

ECU

FabrikantLUCAS
ModelPLCC 28HC256
Geheugen / EPROM28HC256 PLCC32 256Kbit - EEprom 32K x 8

Beschikbare tuning-opties:

  • Injection at idle speed
  • Injection at part load
  • Injection at full throttle
  • Torque limiter
  • Smoke limiter at idle speed
  • Smoke limiter at part load
  • Smoke limiter at full throttle

Firmware-identificatoren (13)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
03161965XXXX1948 1.55.106 LUCAS PLCC 28HC256
03161965XXXX1480 1.55.005 LUCAS PLCC 28HC256
08192397XXXX1945 1.55.002 LUCAS PLCC 28HC256
08192397XXXX3674 1.55.115 LUCAS PLCC 28HC256
08192397XXXX3671 1.55.003 LUCAS PLCC 28HC256
08192397XXXX1948 1.55.005 LUCAS PLCC 28HC256
20412508XXXX1945 1.55.002 LUCAS PLCC 28HC256
20412508XXXX1948 1.55.004 LUCAS PLCC 28HC256
20412508XXXX3671 1.55.005 LUCAS PLCC 28HC256
20412508XXXX3P01 1.55.003 LUCAS PLCC 28HC256
20412508XXXX3674 1.55.105 LUCAS PLCC 28HC256
20577133XXXX3075 1.55.108 LUCAS PLCC 28HC256
20577133XXXX8863 1.55.003 LUCAS PLCC 28HC256

ECU-notities

Original EPROM 28HC256 PLCC 32 pins To read this EPROM with the EMP20 programmer you need PD28 adapters. Attention !! The EMP21 instead needs the PD32 adapters. On this epron can be set a KEY. WARNING !! With the eprom programmer EMP21 at first select device, then choose "DEVICE OPTIONS" and then "DISABLE SDP AFTER PROGRAM" (confirm with "OK"). With EMP20 once the eprom has been programmed, select "B" for disable data protection and confirm with "Y". This Setting File can be used for serial system NewGenius.