VOLKSWAGEN POLO 3 (6N) 2.0L 8V ME7.5.10

ECU BOSCH ME7.5.10 · 116 CV (85 kW) · 2000 cc · Benzina aspirato

ECU-databaseVOLKSWAGEN › VOLKSWAGEN POLO 3 (6N) 2.0L 8V ME7.5.10

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 3 firmwareversies

Voertuiggegevens

MerkVOLKSWAGEN
ModelPOLO 3 (6N)
Motor2.0L 8V ME7.5.10
Standaard vermogen116 CV / 85 kW
Cilinderinhoud2000 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME7.5.10
Geheugen / EPROM29F400 PSOP44 4Mbit - Flash 256K x 16

Beschikbare tuning-opties:

  • Advance at part load
  • Load / throttle position reference
  • Injection at full throttle
  • Advance limiter
  • Torque limiter
  • Load/throttle position reference - AT
  • Air mass flow

Firmware-identificatoren (3)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
02612077161037366105 1.21.00706A906032KH 2702 BOSCH ME7.5.10
02612082231037372251 1.21.00606A906032PB 0305 BOSCH ME7.5.10
02612082231037368063 1.21.00406A906032PB 0304 BOSCH ME7.5.10

ECU-notities

Original EPROM PSOP 44 pins 29F400BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! On this epron can be set a KEY.
Original EPROM PSOP 44 pins 29F400BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! This Setting File can be used for serial system NewGenius. Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator.