Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.
✓ Tuning via bestand (flash)
✓ Aanvullende module beschikbaar 10 firmwareversies
Voertuiggegevens
| Merk | VOLKSWAGEN |
| Model | PASSAT 7 (B7) |
| Motor | 2.5L 20V FSI 125kW/168HP ME17.5.6 |
| Standaard vermogen | 170 CV / 125 kW |
| Cilinderinhoud | 2500 cc |
| Brandstof | Benzina aspirato |
| Voertuigtype | Auto |
ECU
| Fabrikant | BOSCH |
| Model | ME17.5.6 |
| Geheugen / EPROM | MICRO ST TRICORE - 16384 Kbit - 200000 |
Beschikbare tuning-opties:
- Base timing
- Advance at idle speed
- Optimal spark timing/MBT
- Knock correction advance max
- Desired engine load calculation
- Lambda correction for engine temperature after starting
- Exhaust gas temperature
- Speed / RPM limiter
- Lambda enrichment for components protection
- Lambda correction for exhaust manifold temperature
- RPM Limiter
- RPM Limiter 2
- RPM limiter 3
- Lambda driver wish
- Knock detection factor
- Throttle air mass flow calculation
- Manifold absolute pressure time delay
- Characteristic manifold absolute pressure time constant of the LRS
- Optimal engine moment
- Power limit torque table
- Relative permissible torque from the pedal position in torque limitation
- Driver torque request
- Throttle angle management
Firmware-identificatoren (10)
| Hardware-nr. | Software-nr. (chip) | Versie | Update-software | ECU |
|---|
| — | — |
1.94.007 | 07K906055CR 5852 |
BOSCH ME17.5.6 |
| — | — |
1.94.004 | 07K906055DT 1303 |
BOSCH ME17.5.6 |
| — | — |
1.94.006 | 07K906055DT 1302 |
BOSCH ME17.5.6 |
| — | — |
1.94.021 | 07K906055AN 1102 |
BOSCH ME17.5.6 |
| — | — |
1.94.007 | 07K906055EG 4162 |
BOSCH ME17.5.6 |
| — | — |
1.94.004 | 07K906055DD 4338 |
BOSCH ME17.5.6 |
| — | — |
1.94.006 | 07K906055CB 1202 |
BOSCH ME17.5.6 |
| — | — |
1.94.004 | 07K906055DS 1303 |
BOSCH ME17.5.6 |
| — | — |
1.94.002 | 07K906055CR 4340 |
BOSCH ME17.5.6 |
| — | — |
1.94.002 | 07K906055CN 5873 |
BOSCH ME17.5.6 |
ECU-notities
MICRO Infineon Tricore TC1767 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
MICRO Infineon Tricore TC1766 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata
Verkrijg het bestand voor dit voertuig
Tools om deze ECU te lezen en schrijven
