VOLKSWAGEN PASSAT 6 (B6) 1.8L 16V TSI 118kW/158HP MED17

ECU BOSCH MED17.5 · 160 CV (118 kW) · 1800 cc · Benzina sovralimentato

ECU-databaseVOLKSWAGEN › VOLKSWAGEN PASSAT 6 (B6) 1.8L 16V TSI 118kW/158HP MED17

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 33 firmwareversies

Voertuiggegevens

MerkVOLKSWAGEN
ModelPASSAT 6 (B6)
Motor1.8L 16V TSI 118kW/158HP MED17
Standaard vermogen160 CV / 118 kW
Cilinderinhoud1800 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMED17.5
Geheugen / EPROMMICRO ST TRICORE - 12032 Kbit - 178000

Beschikbare tuning-opties:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Optimal spark timing/MBT
  • Advance correction
  • Height correction for boost pressure
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Maximum pressure ratio limit for diagnosis
  • Exhaust gas temperature
  • Filling factor limit
  • Filling factor limit 2
  • Factor for reducing maximum filling
  • Gearbox maximum torque allowed
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • High fuel pressure pump limit
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Torque limiter at high EGT
  • RPM Limiter
  • Lambda driver wish
  • Knock detection factor
  • Maximum boost pressure load
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation - sport/race mode
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Driver torque request AWD
  • Driver torque request for reverse gear
  • Exhaust gas temperature sensor
  • Throttle angle management

Firmware-identificatoren (33)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.94.01106J906026CC 2064 BOSCH MED17.5
1.94.02106J906026AD 1229 BOSCH MED17.5
1.94.00906J906026CC 7219 BOSCH MED17.5
1.94.01006J906026AD 2939 BOSCH MED17.5
1.94.00606J997026G 5705 BOSCH MED17.5
1.94.0101KD907115B 0030 BOSCH MED17.5
1.94.01006J906026B 1475 BOSCH MED17.5
1.94.01106J997026F 5704 BOSCH MED17.5
1.94.01106J906026Q 1577 BOSCH MED17.5
1.94.00906J906026CR 3132 BOSCH MED17.5
1.94.01406J906026 2444 BOSCH MED17.5
1.94.02606J906026 2932 BOSCH MED17.5
1.94.01006J906026BL 3433 BOSCH MED17.5
1.94.01006J906026R 1423 BOSCH MED17.5
1.94.00906J906026R 1578 BOSCH MED17.5
1.94.00206J906026 6974 BOSCH MED17.5
02612015371037391697 1.94.00406J906026 1756 BOSCH MED17.5
1.94.02206J906027B 8317 BOSCH MED17.5.2
1.94.01306J906027DE 5359 BOSCH MED17.5.2
1.94.02706J906027BL 9876 BOSCH MED17.5.2
1.94.00906J997027E 8512 BOSCH MED17.5.2
1.94.01706J906027DE 2283 BOSCH MED17.5.2
1.94.00906J997027E 4499 BOSCH MED17.5.2
1.94.02906J906027AL 8498 BOSCH MED17.5.2
1.94.02206J906027AL 8633 BOSCH MED17.5.2
1.94.01006J906027HM 7824 BOSCH MED17.5.2
1.94.02206J906027HG 7821 BOSCH MED17.5.2
1.94.01906J906027DQ 3841 BOSCH MED17.5.2
1.94.01606J906027ED 3915 BOSCH MED17.5.2
1.94.01606J906027BK 3971 BOSCH MED17.5.2
1.94.04106J906027 9007 BOSCH MED17.5.2
1.94.02206J906027BK 5383 BOSCH MED17.5.2
1.94.01206J997027F 7706 BOSCH MED17.5.2

ECU-notities

MICRO Infineon Tricore TC1766 ATTENTION!! On this car only serial reprogramming is possible. This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata
MICRO Infineon Tricore TC1766 ATTENTION!! On this car only serial reprogramming is possible. This Setting File can be used for serial system NewGenius.
MICRO Infineon Tricore TC1767 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
MICRO Infineon Tricore TC1766 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop