VOLKSWAGEN BEETLE/MAGGIOLINO (A5) 2.5L 20V 125kW/168HP ME17.5.6

ECU BOSCH ME17.5.6 · 170 CV (125 kW) · 2500 cc · Benzina aspirato

ECU-databaseVOLKSWAGEN › VOLKSWAGEN BEETLE/MAGGIOLINO (A5) 2.5L 20V 125kW/168HP ME17.5.6

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 4 firmwareversies

Voertuiggegevens

MerkVOLKSWAGEN
ModelBEETLE/MAGGIOLINO (A5)
Motor2.5L 20V 125kW/168HP ME17.5.6
Standaard vermogen170 CV / 125 kW
Cilinderinhoud2500 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME17.5.6
Geheugen / EPROMMICRO ST TRICORE - 16384 Kbit - 200000

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Knock correction advance max
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Speed / RPM limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • Lambda driver wish
  • Knock detection factor
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Driver torque request
  • Throttle angle management

Firmware-identificatoren (4)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.94.00607K906055E 1154 BOSCH ME17.5.6
1.94.00507K906055E 3689 BOSCH ME17.5.6
1.94.00407K906055CQ 4729 BOSCH ME17.5.6
1.94.00207K906055CQ 4344 BOSCH ME17.5.6

ECU-notities

MICRO Infineon Tricore TC1766 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata
MICRO Infineon Tricore TC1767 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata