VOLKSWAGEN ARTEON 2.0L L4 16V TDI 176kW/236HP DSG DQ500 MQB

ECU TEMIC DQ500 MQB · 239 CV (176 kW) · 2000 cc · Diesel sovralimentato

ECU-databaseVOLKSWAGEN › VOLKSWAGEN ARTEON 2.0L L4 16V TDI 176kW/236HP DSG DQ500 MQB

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkVOLKSWAGEN
ModelARTEON
Motor2.0L L4 16V TDI 176kW/236HP DSG DQ500 MQB
Standaard vermogen239 CV / 176 kW
Cilinderinhoud2000 cc
BrandstofDiesel sovralimentato
VoertuigtypeAuto

ECU

FabrikantTEMIC
ModelDQ500 MQB
Geheugen / EPROMMicro Renesas - 20480 Kbit

Beschikbare tuning-opties:

  • Maximum time for gear downshift
  • Time shift
  • Time shift with torque reduction
  • Time shift with torque reduction 2
  • Engagement time for gear overlap
  • Maximum torque limitation at clutch
  • Clutch torque reduction factor
  • Gearbox torque limiter
  • Gearbox torque limiter 2
  • Maximum torque reduction in ECO (D)
  • Maximum torque reduction during launch control
  • Maximum torque reduction in MANUAL
  • Maximum torque reduction in SPORT (S)
  • RPM limiter
  • RPM limiter - N
  • Maximum torque allowed for gear upshift
  • Gearbox torque limiter for ECT sensor
  • Engine torque limiter depending on vehicle speed
  • Maximum allowable oil pressure
  • Maximum oil pressure allowed at the clutch
  • Maximum upshifting time for 2 gears
  • Maximum upshifting time for 3 gears
  • Maximum upshifting time for 4 gears
  • Maximum upshifting time for 5 gears
  • Oil pressure during adaptations
  • Oil pressure correction based on TOT
  • Gear based pressure verification
  • Shift time with torque reduction
  • Shift timing for gear downshift without load

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
0DL300012R 1.94.0030DL300012R 2103 TEMIC DQ500 MQB

ECU-notities

Microprocessor SH72549 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata