SKODA RAPID (NH) 1.0L TSI 3L 12V 81kW/109HP MED17.1.27

ECU BOSCH MED17.1.27 · 110 CV (81 kW) · 1000 cc · Benzina sovralimentato

ECU-databaseSKODA › SKODA RAPID (NH) 1.0L TSI 3L 12V 81kW/109HP MED17.1.27

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkSKODA
ModelRAPID (NH)
Motor1.0L TSI 3L 12V 81kW/109HP MED17.1.27
Standaard vermogen110 CV / 81 kW
Cilinderinhoud1000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMED17.1.27
Geheugen / EPROMMICRO ST TRICORE - 32768 - 400000

Beschikbare tuning-opties:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Optimal spark timing/MBT
  • Boost pressure limiter
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor for reducing maximum filling
  • Gearbox maximum torque allowed
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum compression ratio
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.94.00804C906025Q 6200 BOSCH MED17.1.27

ECU-notities

MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata