SEAT LEON (KL) 2.0L L4 16V TDI 110kW/148HP DSG DQ38X

ECU BOSCH DQ381 · 150 CV (11 kW) · 2000 cc · Diesel sovralimentato

ECU-databaseSEAT › SEAT LEON (KL) 2.0L L4 16V TDI 110kW/148HP DSG DQ38X

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 1 firmwareversies

Voertuiggegevens

MerkSEAT
ModelLEON (KL)
Motor2.0L L4 16V TDI 110kW/148HP DSG DQ38X
Standaard vermogen150 CV / 11 kW
Cilinderinhoud2000 cc
BrandstofDiesel sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelDQ381
Geheugen / EPROMMicro Renesas - 20480 Kbit

Beschikbare tuning-opties:

  • Gear upshift 1->2
  • Gear upshift 2->3
  • Maximum time for gear downshift
  • Time shift
  • Time shift with torque reduction
  • Time shift with torque reduction 2
  • Maximum torque limitation at clutch
  • Clutch torque reduction factor
  • Gearbox torque limiter
  • Gearbox torque limiter 2
  • Maximum torque reduction in ECO (D)
  • Maximum torque reduction during launch control
  • Maximum torque reduction in MANUAL
  • Maximum torque reduction in SPORT (S)
  • RPM limiter
  • RPM limiter - N
  • RPM limiter - R
  • Maximum torque allowed for gear upshift
  • Gearbox torque limiter for ECT sensor
  • Engine torque limiter depending on vehicle speed
  • Maximum allowable oil pressure
  • Maximum oil pressure allowed at the clutch
  • Maximum upshifting time for 2 gears
  • Maximum upshifting time for 3 gears
  • Maximum upshifting time for 4 gears
  • Maximum upshifting time for 5 gears
  • Oil pressure during adaptations
  • Oil pressure correction based on TOT
  • Gear based pressure verification
  • R-US
  • RPM for the engine stall with ESP OFF
  • Shift time with torque reduction
  • Shift time with torque reduction 2
  • Shift timing for gear downshift without load
  • Vehicle speed target for gear shift

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
0GC906555P 1.94.0050GC906555P 4161 BOSCH DQ381

ECU-notities

Microprocessor SH72549 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop