PORSCHE PANAMERA (971) 4S 2.9L V6 24V TFSI 324kW/434HP MG1CS002

ECU BOSCH MG1CS002 · 441 CV (324 kW) · 2900 cc · Benzina sovralimentato

ECU-databasePORSCHE › PORSCHE PANAMERA (971) 4S 2.9L V6 24V TFSI 324kW/434HP MG1CS002

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 3 firmwareversies

Voertuiggegevens

MerkPORSCHE
ModelPANAMERA (971)
Motor4S 2.9L V6 24V TFSI 324kW/434HP MG1CS002
Standaard vermogen441 CV / 324 kW
Cilinderinhoud2900 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMG1CS002
Geheugen / EPROMMicro BGA FREESCALE - 8192 Kbit - 800000

Beschikbare tuning-opties:

  • Base timing
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio for turbocharger protection
  • Compression ratio limiting for compressor depending on IAT sensor
  • Exhaust gas temperature
  • Filling factor limit
  • Filling factor limit 2
  • Factor for reducing maximum filling
  • Torque limiter 2
  • Torque limiter 3
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Knock detection factor
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management

Firmware-identificatoren (3)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.02.006971907551A 0004 BOSCH MG1CS002
1.02.009971907551 0007 BOSCH MG1CS002
1.02.006971907551L 0002 BOSCH MG1CS002

ECU-notities

Microprocessor BGA FREESCALE SPC57xxx This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):