PORSCHE PANAMERA (971) 3.0L V6 24V TFSI 243kW/326HP MG1CS002

ECU BOSCH MG1CS002 · 330 CV (243 kW) · 3000 cc · Benzina sovralimentato

ECU-databasePORSCHE › PORSCHE PANAMERA (971) 3.0L V6 24V TFSI 243kW/326HP MG1CS002

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 4 firmwareversies

Voertuiggegevens

MerkPORSCHE
ModelPANAMERA (971)
Motor3.0L V6 24V TFSI 243kW/326HP MG1CS002
Standaard vermogen330 CV / 243 kW
Cilinderinhoud3000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMG1CS002
Geheugen / EPROMMicro BGA FREESCALE - 8192 Kbit - 800000

Beschikbare tuning-opties:

  • Base timing
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio for turbocharger protection
  • Compression ratio limiting for compressor depending on IAT sensor
  • Exhaust gas temperature
  • Filling factor limit
  • Filling factor limit 2
  • Factor for reducing maximum filling
  • Torque limiter 2
  • Torque limiter 3
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Knock detection factor
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management

Firmware-identificatoren (4)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.02.005971907559B 0005 BOSCH MG1CS002
1.02.009971907559B 0004 BOSCH MG1CS002
1.02.006971907559A 0005 BOSCH MG1CS002
1.02.011971907559A 0005 BOSCH MG1CS002

ECU-notities

Microprocessor BGA FREESCALE SPC57xxx This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata