PORSCHE 992 3.8L TURBO S 427kW/573HP MG1CP007

ECU BOSCH MG1CP007 · 581 CV (427 kW) · 3800 cc · Benzina sovralimentato

ECU-databasePORSCHE › PORSCHE 992 3.8L TURBO S 427kW/573HP MG1CP007

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 5 firmwareversies

Voertuiggegevens

MerkPORSCHE
Model992
Motor3.8L TURBO S 427kW/573HP MG1CP007
Standaard vermogen581 CV / 427 kW
Cilinderinhoud3800 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMG1CP007
Geheugen / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbyte

Beschikbare tuning-opties:

  • Base timing
  • Base timing 2
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Optimal spark timing/MBT 2
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio for turbocharger protection
  • Compression ratio limiting for compressor depending on IAT sensor
  • Exhaust gas temperature
  • Factor for reducing maximum filling
  • Torque limiter 2
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Turbocharger volumetric efficiency

Firmware-identificatoren (5)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.02.003992906027AH 0001 BOSCH MG1CP007
1.02.005992906027AK 0001 BOSCH MG1CP007
1.02.003992906027AE 0001 BOSCH MG1CP007
1.02.002992906027M 0003 BOSCH MG1CP007
1.02.016992906027R 0001 BOSCH MG1CP007

ECU-notities

Micro Infineon Tricore TC299TP WARNING - New Genius with security Dongle: the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata