PEUGEOT 106 1.1L 8V 44kW/60HP ME7.4/ME7.4.4/M7.4.4

ECU BOSCH M7.4.4 PSA · 60 CV (44 kW) · 1100 cc · Benzina aspirato

ECU-databasePEUGEOT › PEUGEOT 106 1.1L 8V 44kW/60HP ME7.4/ME7.4.4/M7.4.4

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 7 firmwareversies

Voertuiggegevens

MerkPEUGEOT
Model106
Motor1.1L 8V 44kW/60HP ME7.4/ME7.4.4/M7.4.4
Standaard vermogen60 CV / 44 kW
Cilinderinhoud1100 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelM7.4.4 PSA
Geheugen / EPROM29F400 PSOP44 4Mbit - Flash 256K x 16

Beschikbare tuning-opties:

  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda enrichment for components protection
  • RPM Limiter
  • Throttle air mass flow calculation
  • Optimal engine moment

Firmware-identificatoren (7)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
02612062461037353630 1.32.008 BOSCH M7.4.4 PSA
02612062461037353467 1.32.013 BOSCH M7.4.4 PSA
02612062461037353269 1.32.0249642616880 BOSCH M7.4.4 PSA
02612062461037353269 1.32.0059642616880 BOSCH M7.4.4 PSA
02612062461037353162 1.32.0069641727280 BOSCH ME7.4
02612062461037353768 1.32.0059637838780 BOSCH ME7.4
02612062461037353881 1.32.0159648484380 BOSCH ME7.4.4

Technische voertuignotities

OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.

ECU-notities

Original EPROM PSOP 44 pins 29F400BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! This Setting File can be used for serial programming system NewGenius.
Original EPROM PSOP 44 pins 29F400BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. To work on this ECU you can use NewTrasdata