MAZDA 2 (DJ) 1.5L 16V SKYACTIV-G 85kW/114HP PAB1/PAJ1/PAJ9

ECU DENSO PAB1/PAJ1/PAJ9/PX43 · 116 CV (85 kW) · 1500 cc · Benzina aspirato

ECU-databaseMAZDA › MAZDA 2 (DJ) 1.5L 16V SKYACTIV-G 85kW/114HP PAB1/PAJ1/PAJ9

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkMAZDA
Model2 (DJ)
Motor1.5L 16V SKYACTIV-G 85kW/114HP PAB1/PAJ1/PAJ9
Standaard vermogen116 CV / 85 kW
Cilinderinhoud1500 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
ModelPAB1/PAJ1/PAJ9/PX43
Geheugen / EPROMMICRO BGA FREESCALE MPC5746R

Beschikbare tuning-opties:

  • Base timing
  • Base timing 2
  • Base timing 3
  • Base timing in deceleration
  • Base timing in recovery mode
  • Base timing correction at idle speed
  • Lambda/AFR full load/WOT
  • Advance correction for IAT sensor
  • Desired engine load calculation
  • Coil charge time
  • Exhaust gas temperature
  • Exhaust gas temperature 2
  • Indicated engine torque
  • Engine idle vs. ECT sensor
  • Engine idle vs. ECT sensor 2
  • Gear ratio
  • High pressure fuel pump setpoint
  • High pressure fuel pump setpoint 2
  • High fuel pressure pump limit
  • Lambda/AFR - closed loop
  • Lambda target value - open loop
  • Torque limiter
  • Lambda enrichment for exhaust protection
  • RPM Limiter
  • RPM limiter - N
  • Speed limiter
  • Maximum advance allowed
  • Rev limiter hysteresis
  • Driver torque request
  • Driver torque request for reverse gear
  • Driver torque request Sport mode
  • Throttle angle limitation
  • Torque limit table for IAT sensor
  • Volumetric efficiency
  • Variable valve timing - inlet
  • Variable valve timing - inlet - 2
  • Variable valve timing - outlet
  • Variable valve timing - outlet 2

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
PYFB-188K1-P5S5-18881- 1.00.011P5S5-188K2- DENSO PAB1/PAJ1/PAJ9/PX43

ECU-notities

Microprocessor MPC5746R This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata