LINCOLN NAVIGATOR Mk4 3.5L V6 Ecoboost 285kW/382HP MG1CS015

ECU BOSCH MG1CS015 · 387 CV (285 kW) · 3500 cc · Benzina sovralimentato

ECU-databaseLINCOLN › LINCOLN NAVIGATOR Mk4 3.5L V6 Ecoboost 285kW/382HP MG1CS015

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkLINCOLN
ModelNAVIGATOR Mk4
Motor3.5L V6 Ecoboost 285kW/382HP MG1CS015
Standaard vermogen387 CV / 285 kW
Cilinderinhoud3500 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMG1CS015
Geheugen / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 384Kbyte

Beschikbare tuning-opties:

  • Base timing
  • Max threshold air mass flow throught compressor
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Part pedal combustion load limit
  • Compressor pressure ratio limit for pumping and speed
  • Engine indicated torque at stoichiometric
  • Lambda enrichment - open loop
  • Max desired pressure ratio limit
  • Lambda driver wish
  • Lambda driver wish 2
  • Knock detection factor
  • Load limit at high effectiveness of LSPI mitigation
  • Load limit at low effectiveness of LSPI mitigation
  • Load limit at nominal effectiveness of LSPI mitigation
  • Maximum advance allowed
  • Intake manifold pressure
  • Maximum indicated torque
  • Maximum indicated torque for monitoring
  • Maximum indicated torque (overboost active)
  • Minimum indicated torque for monitoring
  • Max load
  • Max load at WOT
  • Maximum intake manifold pressure
  • Maximum throttle angle opening for a given RPM
  • Overall LSPI load limit
  • Pressure ratio limit for overboost detection
  • Requested crankshaft/transmission torque
  • Wastegate duty-cycle
  • Max tip at wastegate

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
F111-XXXXXX-YYF113-XXXXXX-YY 1.94.016ML7A-14C204-AFD BOSCH MG1CS015

ECU-notities

Micro Infineon Tricore TC277TP This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata