LAMBORGHINI HURACAN 5.2L V10 LP 580-4 427kW/573HP MED17.1.1

ECU BOSCH MED17.1.1 · 581 CV (427 kW) · 5200 cc · Benzina aspirato

ECU-databaseLAMBORGHINI › LAMBORGHINI HURACAN 5.2L V10 LP 580-4 427kW/573HP MED17.1.1

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 6 firmwareversies

Voertuiggegevens

MerkLAMBORGHINI
ModelHURACAN
Motor5.2L V10 LP 580-4 427kW/573HP MED17.1.1
Standaard vermogen581 CV / 427 kW
Cilinderinhoud5200 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMED17.1.1
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • High pressure fuel pump setpoint
  • High pressure fuel pump setpoint 2
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • Knock detection factor
  • Speed limiter
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Relative permissible torque from the pedal position in torque limitation
  • Driver torque request
  • Driver torque request for reverse gear
  • Torque limiter for selected gear
  • Throttle angle management

Firmware-identificatoren (6)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.94.0094T0907552Q 0003 BOSCH MED17.1.1
1.94.0114T0907552L 0002 BOSCH MED17.1.1
1.94.0124T0907552H 0001 BOSCH MED17.1.1
1.94.0074T0907552AL 0001 BOSCH MED17.1.1
1.94.0054T0907552AM 0001 BOSCH MED17.1.1
1.94.0074T0907552M 0006 BOSCH MED17.1.1

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata