KAWASAKI Z 1000 20-> 118kW

ECU DENSO 21175-1363 · 160 CV (118 kW) · 1000 cc · Benzina aspirato

ECU-databaseKAWASAKI › KAWASAKI Z 1000 20-> 118kW

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkKAWASAKI
ModelZ 1000
Motor20-> 118kW
Standaard vermogen160 CV / 118 kW
Cilinderinhoud1000 cc
BrandstofBenzina aspirato
VoertuigtypeMoto

ECU

FabrikantDENSO
Model21175-1363
Geheugen / EPROMMicro RENESAS - 8192 Kbit -100000

Beschikbare tuning-opties:

  • Base timing - full power
  • Base timing - low power
  • Base timing - clutch/neutral
  • Load / throttle position reference
  • Exhaust valve management in deceleration - gear based - full power
  • Exhaust valve management in deceleration - gear based - low power
  • Exhaust valve management - gear based - full power
  • Exhaust valve management - gear based - low power
  • Engine idle vs. ECT sensor
  • Injection for IAP - full power
  • Injection for IAP - low power
  • Injection for TPS - full power
  • Injection for TPS - low power
  • RPM Limiter
  • RPM Limiter 2
  • Ram Air
  • Secondary throttle plates management in deceleration - gear based - full power
  • Secondary throttle plates management in deceleration - gear based - low power
  • Secondary throttle plates management - gear based - full power
  • Secondary throttle plates management - gear based - low power
  • Cooling fan activation
  • Traction control - activation sensitivity
  • Traction control - slip sensitivity
  • Traction control - TPS correction

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
21175-1363KPHPK8H0 1.00.01549245-1321 DENSO 21175-1363

ECU-notities

Microprocessor SH7058 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata