JEEP RENEGADE (BU) 1.4L 16V Multiair 103kW/138HP IAW8GMK — ECU MARELLI 8GMK/8GML

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 10 firmwareversies

Verkrijg het bestand voor dit voertuig

Koop het bestand (origineel of geremapt)Registreer op mastertuningfile.com en bestel het bestand

Ben je een garage of tuner?

Voertuiggegevens

Merk	JEEP
Model	RENEGADE (BU)
Motor	1.4L 16V Multiair 103kW/138HP IAW8GMK
Standaard vermogen	140 CV / 103 kW
Cilinderinhoud	1400 cc
Brandstof	Benzina sovralimentato
Voertuigtype	Auto

ECU

Fabrikant	MARELLI
Model	8GMK/8GML
Geheugen / EPROM	Micro BGA STSPC564A80 - 32748Kbit - 400000

Beschikbare tuning-opties:

Base timing
Spark advance correction for ECT sensor
Advance correction for IAT sensor
Base lambda - cold
Base Lambda - hot
Boost pressure limiter
Electronic throttle control
Compressor pressure ratio limit for pumping and speed
Average power effective limitation
Average torque effective limitation
Torque limiter
Maximum Upstream pressure in event of Normal boost modality
Maximum Upstream pressure in event of normal boost modality, Offroad mode activated
Maximum Upstream pressure in event of normal boost modality, Sport mode activated
Maximum Upstream pressure in event of overboost modality
Maximum Upstream pressure in event of overboost modality, Offroad modality activated
Maximum Upstream pressure in event of overboost modality, Sport modality activated
Max torque profile
Torque management in Normal mode
Torque management in Normal mode 2
Torque management in Normal mode 3
Torque management in Offroad mode
Torque management Sport mode
Torque management in Sport mode 3
Power Control in Normal mode
Power Control in Offroad mode
Power Control in Sport mode
Power limit torque table
Resistant torque table
Torque limit table for ECT sensor
Take-off torque law in Offroad mode
Take-off torque law in Offroad mode 2
Take-off torque law in Offroad mode with power control
Take-off torque law in Normal mode
Take-off torque law in Normal mode 2
Take-off torque law in Normal mode with power control
Take-off torque law in Sport mode
Take-off torque law in Sport mode 2
Take-off torque law in Sport mode with power control
Wastegate duty-cycle

Firmware-identificatoren (10)

Hardware-nr.	Software-nr. (chip)	Versie	Update-software	ECU
MM8GMKHW670	V723NG64	1.91.017	V723NG64	MARELLI 8GMK/8GML
MM8GMKHW670	V862NG81	1.01.008	V862NG81	MARELLI 8GMK/8GML
MM8GMKHW670	V713MG82	1.91.027	V713MG82	MARELLI 8GMK/8GML
MM8GMKHW670	V723NG66	1.91.012	V723NG66	MARELLI 8GMK/8GML
MM8GMKHW670	V631MG77	1.01.012	V631MG77	MARELLI 8GMK/8GML
MM8GMKHW670	V861MG96	1.01.022	V861MG96	MARELLI 8GMK/8GML
MM8GMKHW670	V862QG96	1.01.009	V862QG96	MARELLI 8GMK/8GML
MM8GMKHW670	V714MG86	1.01.012	V714MG86	MARELLI 8GMK/8GML
MM8GMKHW670	V862MG99	1.01.012	V862MG99	MARELLI 8GMK/8GML
MM8GMKHW690	053090AC	1.91.016	053090AC	MARELLI 8GMK/8GML

ECU-notities

Microprocessor BGA SPC564A80 This Setting File can be used for serial system NewGenius. ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual. To work on this ECU you can use NewTrasdata