JAGUAR F-PACE (X761) 3.0L 24V V6 250kW/335HP MED17.8.32

ECU BOSCH MED17.8.32 · 340 CV (25 kW) · 3000 cc · Benzina sovralimentato

ECU-databaseJAGUAR › JAGUAR F-PACE (X761) 3.0L 24V V6 250kW/335HP MED17.8.32

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 3 firmwareversies

Voertuiggegevens

MerkJAGUAR
ModelF-PACE (X761)
Motor3.0L 24V V6 250kW/335HP MED17.8.32
Standaard vermogen340 CV / 25 kW
Cilinderinhoud3000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMED17.8.32
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Average power effective limitation
  • Gearbox maximum torque allowed
  • High pressure fuel pump setpoint
  • High pressure fuel pump setpoint 2
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limit for ECT sensor
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Maximum pressure ratio limit depending on ECT
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Torque limiter for selected gear
  • Throttle angle management

Firmware-identificatoren (3)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
HPLA-14C568-TB 1.94.005JK83-14C570-UTD BOSCH MED17.8.32
HPLA-14C568-TB 1.94.006JK83-14C570-UAE BOSCH MED17.8.32
HPLA-14C568-TB 1.94.005KX53-14C570-UTD BOSCH MED17.8.32

ECU-notities

MICRO Infineon Tricore TC1797 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata