HYUNDAI i30 MK3 (PD) 1.4L 16V T-GDI 103kW/138HP CPEGD2.20.1/2

ECU KEFICO CPEGD2.20.1/2 · 140 CV (103 kW) · 1400 cc · Benzina sovralimentato

ECU-databaseHYUNDAI › HYUNDAI i30 MK3 (PD) 1.4L 16V T-GDI 103kW/138HP CPEGD2.20.1/2

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 7 firmwareversies

Voertuiggegevens

MerkHYUNDAI
Modeli30 MK3 (PD)
Motor1.4L 16V T-GDI 103kW/138HP CPEGD2.20.1/2
Standaard vermogen140 CV / 103 kW
Cilinderinhoud1400 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantKEFICO
ModelCPEGD2.20.1/2
Geheugen / EPROMMICRO ST TRICORE - 20480 Kbit - 280000

Beschikbare tuning-opties:

  • Base timing
  • Base timing 2
  • Knock correction advance max
  • Desired engine load calculation
  • Desired pressure ratio
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • Factor for reducing maximum filling
  • Advance limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Lambda driver wish
  • Knock detection factor
  • Lookup table minimum defined efficiency
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Turbocharger volumetric efficiency

Firmware-identificatoren (7)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
HEPG41DB 1.94.005GTPDEJE64FS00H0K KEFICO CPEGD2.20.1/2
HEPG3D28 1.94.009GTPD-HA56FS01H00 KEFICO CPEGD2.20.1/2
HEPG3D28 1.94.005GTPD-HA56FS02600 KEFICO CPEGD2.20.1/2
HEPG41DB 1.94.016GTPDEJE64FS0160K KEFICO CPEGD2.20.1/2
HEPG35C6 1.94.008GTPD-HA56FS00600 KEFICO CPEGD2.20.1/2
HEPG394D 1.94.009GTPDEHE64FS0360K KEFICO CPEGD2.20.1/2
HEPG3D28 1.94.005GTPD-HA56FS01600 KEFICO CPEGD2.20.1/2

ECU-notities

Microprocessor TC1782 This Setting File can be used for serial programming system NewGenius. To work on this ECU you can use NewTrasdata