HYUNDAI i30 MK1 (FD) 1.6L 16V 92kW/123HP M7.9.8

ECU BOSCH M7.9.8/MG7.9.8 · 125 CV (92 kW) · 1600 cc · Benzina aspirato

ECU-databaseHYUNDAI › HYUNDAI i30 MK1 (FD) 1.6L 16V 92kW/123HP M7.9.8

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 5 firmwareversies

Voertuiggegevens

MerkHYUNDAI
Modeli30 MK1 (FD)
Motor1.6L 16V 92kW/123HP M7.9.8
Standaard vermogen125 CV / 92 kW
Cilinderinhoud1600 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelM7.9.8/MG7.9.8
Geheugen / EPROMMICRO ST - 6656 Kbit

Beschikbare tuning-opties:

  • Advance at idle speed
  • Advance at part load
  • Injection at part load
  • Advance limiter
  • Torque limiter
  • RPM Limiter
  • Speed limiter
  • Air mass flow
  • Injection correction Lambda sensor 1

Firmware-identificatoren (5)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
9001040164GFD_A44CFS1_5000 1.06.002 BOSCH M7.9.8/MG7.9.8
9001040172GFD_AH6CFS2_5000 1.14.005 BOSCH M7.9.8/MG7.9.8
90010403891037370463 1.14.003 BOSCH M7.9.8/MG7.9.8
90030502041037370463 1.14.003 BOSCH M7.9.8/MG7.9.8
90309330121037370463 1.14.003 BOSCH M7.9.8/MG7.9.8

ECU-notities

Microprocessor ST10F275 ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! To work on this ECU you can use NewTrasdata
Microprocessor ST10F275 To work on this ECU you can use NewTrasdata Warning! Lambda correction map, it is necessary to reduce the value to enrich the mixture.