FIAT ULYSSE Mk2 2.2L 8V JTD 94kW/126HP EDC15

ECU BOSCH EDC15C2 · 128 CV (94 kW) · 2200 cc · Diesel sovralimentato

ECU-databaseFIAT › FIAT ULYSSE Mk2 2.2L 8V JTD 94kW/126HP EDC15

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 10 firmwareversies

Voertuiggegevens

MerkFIAT
ModelULYSSE Mk2
Motor2.2L 8V JTD 94kW/126HP EDC15
Standaard vermogen128 CV / 94 kW
Cilinderinhoud2200 cc
BrandstofDiesel sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelEDC15C2
Geheugen / EPROM29F400 PSOP44 4Mbit - Flash 256K x 16

Beschikbare tuning-opties:

  • Boost pressure limiter
  • Boost pressure
  • EGR valve control
  • Injection at part load
  • Injection at full throttle
  • Torque limiter
  • Smoke limiter
  • Specific injection pressure limiter
  • Specific injection pressure
  • Air mass flow
  • Overboost timing

Firmware-identificatoren (10)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
02810108811037353780 1.05.0081037353780 BOSCH EDC15C2
02810110331037353937 1.05.0201037353937 BOSCH EDC15C2
02810110331037364376 1.05.0151037364376 BOSCH EDC15C2
02810111331037364400 1.05.0151037364400 BOSCH EDC15C2
02810113631037368404 1.05.0121037368404 BOSCH EDC15C2
02810115221037368845 1.05.0081037368845 BOSCH EDC15C2
02810115221037370785 1.05.0121037370785 BOSCH EDC15C2
02810117791037375143 1.05.0091037375143 BOSCH EDC15C2
02810121411037376105 1.05.0081037378622 BOSCH EDC15C2
02810121411037378622 1.05.0071037378622 BOSCH EDC15C2

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

Original EPROM PSOP 44 pins 29F400BT. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. This Setting File can be used for serial system : Genius or NewGenius.
Original EPROM PSOP 44 pins 29F400BT. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. This Setting File can be used for serial programming system NewGenius.

Aanvullende modules beschikbaar

→ See all add-on modules on the shop