FIAT PUNTO GRANDE (199) 1.4L 16V TJET 88kW/118HP ME7.9.10

ECU BOSCH ME7.9.10 · 120 CV (88 kW) · 1400 cc · Benzina sovralimentato

ECU-databaseFIAT › FIAT PUNTO GRANDE (199) 1.4L 16V TJET 88kW/118HP ME7.9.10

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 6 firmwareversies

Voertuiggegevens

MerkFIAT
ModelPUNTO GRANDE (199)
Motor1.4L 16V TJET 88kW/118HP ME7.9.10
Standaard vermogen120 CV / 88 kW
Cilinderinhoud1400 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME7.9.10
Geheugen / EPROMMICRO ST - 6656 Kbit

Beschikbare tuning-opties:

  • Base timing
  • Optimal spark timing/MBT
  • Spark advance correction for ECT sensor
  • Advance correction
  • Boost pressure
  • Desired engine load calculation
  • Compression ratio for turbocharger protection
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • Lambda enrichment for components protection
  • RPM Limiter
  • RPM limit for ECT sensor
  • RPM limit for EOT sensor
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Max torque profile
  • Max torque profile (overboost active)
  • Optimal engine moment
  • Driver torque request
  • Driver torque request for reverse gear
  • Driver torque request Sport mode
  • Throttle angle management
  • Turbocharger volumetric efficiency
  • Wastegate duty-cycle

Firmware-identificatoren (6)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.91.017 BOSCH ME7.9.10
02612016841037390454 1.91.033 BOSCH ME7.9.10
02612016841037391689 1.91.034 BOSCH ME7.9.10
02612016871037390452 1.91.021 BOSCH ME7.9.10
0261S046601037397659 1.91.023 BOSCH ME7.9.10
0261S046611037397660 1.91.004 BOSCH ME7.9.10

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

Microprocessor ST10F275 This Setting File can be used for serial system : Genius or NewGenius. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop