FIAT LINEA 1.4L 16V 88kW/118HP ME7.9.10

ECU BOSCH ME7.9.10 · 120 CV (88 kW) · 1400 cc · Benzina sovralimentato

ECU-databaseFIAT › FIAT LINEA 1.4L 16V 88kW/118HP ME7.9.10

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkFIAT
ModelLINEA
Motor1.4L 16V 88kW/118HP ME7.9.10
Standaard vermogen120 CV / 88 kW
Cilinderinhoud1400 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME7.9.10
Geheugen / EPROMMICRO ST - 6656 Kbit

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Spark advance correction for ECT sensor
  • Boost pressure limiter
  • Boost pressure
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio for turbocharger protection
  • Desired pressure ratio
  • Exhaust gas temperature
  • Injection at part load
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM limiter 3
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Max torque profile
  • Max torque profile (overboost active)
  • Optimal engine moment
  • Boost pressure threshold cycles for the overboost recognition
  • Offset tolerance depending on permissible torque
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request for low speed
  • Driver torque request for low speed in Sport mode
  • Throttle angle management
  • Turbocharger volumetric efficiency
  • Wastegate duty-cycle

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
02612016891037392096 1.91.003 BOSCH ME7.9.10

ECU-notities

Microprocessor ST10F275 This Setting File can be used for serial system : Genius or NewGenius. To work on this ECU you can use NewTrasdata