DUCATI MULTISTRADA V2 22->24 83kW

ECU BOSCH ME17.9.21 · 113 CV (83 kW) · 937 cc · Benzina aspirato

ECU-databaseDUCATI › DUCATI MULTISTRADA V2 22->24 83kW

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkDUCATI
ModelMULTISTRADA V2
Motor22->24 83kW
Standaard vermogen113 CV / 83 kW
Cilinderinhoud937 cc
BrandstofBenzina aspirato
VoertuigtypeMoto

ECU

FabrikantBOSCH
ModelME17.9.21
Geheugen / EPROMMICRO ST TRICORE - 12288 Kbit - 180000

Beschikbare tuning-opties:

  • Base timing
  • Minimum advance allowed
  • Minimum advance allowed protection
  • Optimal spark timing/MBT
  • Advance at part load
  • Knock correction advance max
  • Desired engine load calculation
  • Desired engine load calculation 2
  • Lambda correction f(IAT)
  • Desired throttle angle
  • Exhaust gas temperature
  • Exhaust gas temperature threshold for component protection
  • Engine torque limit for transmission protection
  • Factor to correct fuel delivery system
  • Engine idle vs. ECT sensor
  • Engine idle vs. ECT sensor 2
  • Rpm threshold fuel cut
  • Lambda enrichment for components protection
  • Lambda minimum value for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM limiter - N
  • RPM limiter - R
  • Speed limiter
  • Throttle air mass flow calculation
  • Maximum throttle angle opening for a given RPM
  • Nominal throttle opening
  • Optimal engine moment
  • Power limit torque table
  • Requested torque map set 1
  • Requested torque map set 1 - monitoring
  • Requested torque map set 1 - monitoring 2
  • Requested torque map set 2
  • Requested torque map set 2 - monitoring
  • Requested torque map set 2 - monitoring 2
  • Requested torque map set 3
  • Requested torque map set 3 - monitoring
  • Requested torque map set 3 - monitoring 2
  • Driver torque request - MT
  • Requested torque map set 4 - monitoring
  • Requested torque map set 4 - monitoring 2

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.91.00810SW094641 BOSCH ME17.9.21

ECU-notities

Microprocessor TC1724 To work on this ECU you can use NewTrasdata This Setting File can be used for serial system NewGenius.