DONKERVOORT D8 GT 1.8L TURBO 200kW/268HP ME7.5/5

ECU BOSCH ME7.5 · 272 CV (2 kW) · 1800 cc · Benzina sovralimentato

ECU-databaseDONKERVOORT › DONKERVOORT D8 GT 1.8L TURBO 200kW/268HP ME7.5/5

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkDONKERVOORT
ModelD8 GT
Motor1.8L TURBO 200kW/268HP ME7.5/5
Standaard vermogen272 CV / 2 kW
Cilinderinhoud1800 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME7.5
Geheugen / EPROM29F800 PSOP44 8Mbit - Flash 512K x 16

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Boost pressure limiter 4
  • Boost pressure limiter 5
  • Boost pressure limit control
  • Height correction for boost pressure
  • Desired engine load calculation
  • Maximum pressure ratio limit for diagnosis
  • Exhaust gas temperature
  • Lambda enrichment for components protection
  • RPM Limiter
  • Boost pressure linearization
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum boost pressure load
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Relative permissible torque from the pedal position in torque limitation
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
02612080011037363650 1.21.013 BOSCH ME7.5
02612080021037363651 1.21.009 BOSCH ME7.5

ECU-notities

Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION!