CMC CIRELLI 7 1.5L TURBO 130kW/174HP MG1US008

ECU BOSCH MG1US008 · 177 CV (13 kW) · 1500 cc · Benzina sovralimentato

ECU-databaseCMC › CMC CIRELLI 7 1.5L TURBO 130kW/174HP MG1US008

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkCMC
ModelCIRELLI 7
Motor1.5L TURBO 130kW/174HP MG1US008
Standaard vermogen177 CV / 13 kW
Cilinderinhoud1500 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMG1US008
Geheugen / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 384Kbyte

Beschikbare tuning-opties:

  • Base timing
  • Knock correction advance max
  • Desired engine load calculation
  • Lambda correction
  • Lambda Correction 2
  • Compression ratio for turbocharger protection
  • Compression ratio limiting for compressor depending on IAT sensor
  • Exhaust gas temperature
  • Exhaust gas temperature 2
  • Factor to correct fuel delivery system
  • Factor for reducing maximum filling
  • Advance limiter for component protection 1
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Lambda driver wish
  • Knock detection factor
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile (overboost active)
  • Optimal engine moment
  • Power limit torque table
  • Driver torque request
  • Torque limiter for selected gear
  • Throttle angle management
  • Turbocharger volumetric efficiency

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
F01RB0DR3H 1.94.013ZH1207AB22 BOSCH MG1US008

Technische voertuignotities

ECU located in the engine bay behind/close to the battery. Difficulty: easy
OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata