CHEVROLET US/EU/SAM SPARK M300 1.0L 16V 56kW/75HP DELCO E78

ECU DELCO E78 · 76 CV (56 kW) · 1000 cc · Benzina aspirato

ECU-databaseCHEVROLET US/EU/SAM › CHEVROLET US/EU/SAM SPARK M300 1.0L 16V 56kW/75HP DELCO E78

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkCHEVROLET US/EU/SAM
ModelSPARK M300
Motor1.0L 16V 56kW/75HP DELCO E78
Standaard vermogen76 CV / 56 kW
Cilinderinhoud1000 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDELCO
ModelE78
Geheugen / EPROMMICRO BGA MOTOROLA FREESCALE con FLASH interna MPC5566 24576 Kbit - 0x300000

Beschikbare tuning-opties:

  • Engine ignition timing versus temperature
  • Advance at idle speed
  • Lambda/AFR full load/WOT
  • Optimal spark timing/MBT
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Desired engine load calculation
  • Variable exhaust camshaft timing 2
  • Variable exhaust camshaft timing
  • ECT for fan engagement
  • Engine idle
  • Engine idle in Park position
  • Variable intake camshaft timing 2
  • Variable intake camshaft timing
  • Torque limiter 2
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Torque limiter for the 1st gear selected
  • Torque limiter for the 2nd gear selected
  • Torque limiter for the 3rd gear selected
  • Torque limiter for the 4th gear selected
  • Torque limiter for the 5th gear selected
  • Torque limiter for the 6th gear selected
  • Torque limiter for for reverse gear
  • Throttle angle management

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1264713612659573 1.91.02425192105 DELCO E78

ECU-notities

Microprocessor FMPC 5566 This Setting File can be used for serial system NewGenius. ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual. To work on this ECU you can use NewTrasdata