CHEVROLET US/EU/SAM SILVERADO Mk3 2.8L 16V L4 TDI 134kW/180HP DELCO E98

ECU DELCO E98 · 182 CV (134 kW) · 2800 cc · Diesel sovralimentato

ECU-databaseCHEVROLET US/EU/SAM › CHEVROLET US/EU/SAM SILVERADO Mk3 2.8L 16V L4 TDI 134kW/180HP DELCO E98

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkCHEVROLET US/EU/SAM
ModelSILVERADO Mk3
Motor2.8L 16V L4 TDI 134kW/180HP DELCO E98
Standaard vermogen182 CV / 134 kW
Cilinderinhoud2800 cc
BrandstofDiesel sovralimentato
VoertuigtypeLCV

ECU

FabrikantDELCO
ModelE98
Geheugen / EPROMMICRO BGA FREESCALE MPC5674F - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Maximum engine boost pressure F (atmospheric pressure)
  • Boost pressure
  • Max torque correction factor for APS sensor
  • Engine idle vs. ECT sensor
  • Injection period
  • Injection opening time related to inj. pressure
  • Initialization values over pressure control valve
  • Torque limiter 3
  • Torque limiter 4
  • Torque limiter
  • RPM Limiter
  • Lambda value of the smoke limitation
  • Speed limiter
  • Maximum indicated torque
  • Pressure control map over pressure regulating valve
  • Specific injection pressure limiter
  • Specific injection pressure limiter for EFT sensor
  • Specific injection pressure
  • Specific air mass charge
  • Q
  • Specific air mass charge 3
  • Delco driver torque request
  • Torque limiter for selected gear
  • Setpoint maximum turbocharger speed
  • Setpoint maximum turbocharger speed - turbocharger protection
  • Torque limiter in recovery mode
  • Torque model - torque to fuel quantity conversion
  • Turbocharger volumetric efficiency

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
A2C92816900055493455 1.83.01312677073 DELCO E98

ECU-notities

Microprocessor BGA FREESCALE MPC5674F This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata