BMW X3 SERIES G01 30i 2.0L L4 16V 185kW/248HP DME__840

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

Voertuiggegevens

ECU

Beschikbare tuning-opties:

• Base timing
• Base timing 2
• Camshaft maximum lift
• Lambda/AFR full load/WOT
• Lambda/AFR mixture at part load
• Optimal spark timing/MBT
• Optimal spark timing/MBT 2
• Knock correction advance max
• Boost pressure limiter for diagnostics
• Maximum torque limitation at clutch
• Desired pressure ratio
• Max accepted exhaust gas temperature value after turbine
• Max accepted exhaust gas pressure at exhaust manifold
• Exhaust gas temperature
• Exhaust gas temperature 2
• Exhaust gas temperature 3
• Exhaust gas temperature 4
• Exhaust gas temperature 5
• Max torque correction factor for knock sensor
• Filling factor limit
• Engine torque reducing factor depending on engine speed
• Engine torque reducing factor depending on temperature
• HFM/HLM threshold for diagnosis
• HFM/HLM air flow high limit
• HFM/HLM air flow low limit
• High pressure fuel pump setpoint
• High fuel pressure pump limit for ECT sensor
• High fuel pressure pump limit 2
• Intake pressure protection
• Intake valve lift - cold
• Intake valve lift - catalyst heating
• Intake valve lift - start for ECT sensor
• Intake valve lift - warm
• Torque limiter 2
• Basic value Lambda sensor
• Torque limiter
• Lambda minimum value for components protection
• Lambda fat-running limit for component protection
• RPM limiter - AT
• RPM limiter - MT
• Knock detection factor
• Speed limiter
• Maximum indicated torque
• Maximum compression ratio
• Maximum possible engine charge
• Maximum engine power
• Maximum engine pressure ratio
• Throttle air mass flow calculation
• Maximum relative engine air charge
• Maximum rail pressure at start-up
• Max torque profile - AT
• Max torque profile - MT
• Optimal engine moment
• Pressure ratio depending on IAT
• Pressure ratio depending on IAT 2
• Requested engine filling
• Driver torque request
• Driver torque request Eco mode - AT
• Driver torque request Eco mode - AT - 2
• Driver torque request Normal mode - AT
• Driver torque request Sport mode - AT
• Driver torque request Sport mode - AT - 2
• Driver torque request Eco mode
• Driver torque request Eco mode - MT
• Driver torque request Eco mode - MT - 2
• Driver torque request Normal mode - MT
• Driver torque request Sport mode - MT
• Driver torque request Sport mode - MT - 2
• Driver torque request Sport mode
• Torque limiter for selected gear
• Torque limiter for selected gear 2
• Torque limiter for selected gear - AT
• Start of injection
• Lambda setpoint switch
• Enrichment interruption duration
• Maximum upper tolerance intake pressure protection
• Torque limit table for IAT sensor
• Lower pressure control threshold
• Torque limiter to prevent preignition
• Torque limiter in recovery mode
• Upper engine rpm threshold for diagnostic control
• Lower engine rpm threshold for diagnostic control
• Upper pressure control threshold
• Turbocharger volumetric efficiency
• Wastegate duty-cycle

Firmware-identificatoren (10)

ECU-notities

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

Rapid FR - Modulo Aggiuntivo Dimsport € 189 Buy Rapid FR Compact 2 - Modulo Aggiuntivo Dimsport € 215 Buy Rapid PRO - Modulo Aggiuntivo Dimsport +15 % € 349 Buy Rapid TPM - Modulo Aggiuntivo Dimsport +15 % € 399 Buy

→ See all add-on modules on the shop

Verkrijg het bestand voor dit voertuig

Tools om deze ECU te lezen en schrijven

Flex Programmatore per rimappatura centraline e cambi automatici ECU + auto gearbox € 1.000 Kopen The Genius OBD + Bench € 2.500 Kopen

Andere BMW

→ Alle ECU's BMW