BMW M8 SERIES G15 4.4L V8 32V 460kW/617HP DME_88T0

ECU BOSCH MG1CS201 (DME_88T0) · 625 CV (46 kW) · 4400 cc · Benzina sovralimentato

ECU-databaseBMW › BMW M8 SERIES G15 4.4L V8 32V 460kW/617HP DME_88T0

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkBMW
ModelM8 SERIES G15
Motor4.4L V8 32V 460kW/617HP DME_88T0
Standaard vermogen625 CV / 46 kW
Cilinderinhoud4400 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMG1CS201 (DME_88T0)
Geheugen / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbyte

Beschikbare tuning-opties:

  • Base timing
  • Base timing 2
  • Camshaft maximum lift
  • Lambda/AFR full load/WOT
  • Optimal spark timing/MBT
  • Optimal spark timing/MBT 2
  • Knock correction advance max
  • Boost pressure limiter for diagnostics
  • Maximum torque limitation at clutch
  • Coolant target temperature
  • Desired pressure ratio
  • Max accepted exhaust gas temperature value after turbine
  • Max accepted exhaust gas pressure at exhaust manifold
  • Exhaust gas temperature
  • Exhaust gas temperature 2
  • Exhaust gas temperature 3
  • Exhaust gas temperature 4
  • Exhaust gas temperature 5
  • Max torque correction factor for knock sensor
  • Filling factor limit
  • Filling factor limit 3
  • Filling factor limit 4
  • Fuel pump speed
  • Fuel pump speed 3
  • Engine torque reducing factor depending on engine speed
  • Engine torque reducing factor depending on temperature
  • RPM limiter in limp mode
  • HFM/HLM threshold for diagnosis
  • HFM/HLM air flow high limit
  • HFM/HLM air flow low limit
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit
  • High fuel pressure pump limit for ECT sensor
  • Intake pressure protection
  • Intake valve lift - cold
  • Intake valve lift - catalyst heating
  • Intake valve lift - start for ECT sensor
  • Intake valve lift - warm
  • Torque limiter 2
  • Torque limiter 3
  • L
  • Torque limiter 5
  • Torque limiter 6
  • Basic value Lambda sensor
  • Torque limiter
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • Lambda minimum value for components protection
  • Lambda fat-running limit for component protection
  • RPM Limiter
  • RPM limiter - AT
  • RPM limiter - MT
  • Low pressure fuel pump for EFT sensor
  • Knock detection factor
  • Speed limiter
  • Maximum indicated torque
  • Maximum compression ratio
  • Maximum possible engine charge
  • Maximum engine pressure ratio
  • Minimum intake manifold pressure
  • Maximum relative engine air charge
  • Maximum rail pressure at start-up
  • Max torque profile - AT
  • Max torque profile - MT
  • Optimal engine moment
  • Pressure ratio depending on IAT
  • Pressure ratio depending on IAT 2
  • Driver torque request
  • Driver torque request Eco mode - AT
  • Driver torque request Eco mode - AT - 2
  • Driver torque request Sport mode - AT
  • Driver torque request Sport mode - AT - 2
  • Driver torque request Eco mode
  • Driver torque request Normal mode - MT
  • Driver torque request Sport mode
  • CAT temperature sensor characterization
  • Torque limiter for selected gear
  • Torque limiter for selected gear - AT
  • Start of injection
  • Maximum upper tolerance intake pressure protection
  • Torque limit table for IAT sensor
  • Lower pressure control threshold
  • Torque limiter to prevent preignition
  • Torque limiter in recovery mode
  • Torque limiter in recovery mode 2
  • Upper engine rpm threshold for diagnostic control
  • Upper pressure control threshold
  • Turbocharger volumetric efficiency
  • Wastegate duty-cycle

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
000048D901230500004ACF1EAA05 1.94.01400005E621EAA32 BOSCH MG1CS201 (DME_88T0)

ECU-notities

Micro Infineon Tricore TC298TP Serial protocol enabled ONLY on New Genius, it does not work on Genius To work on this ECU you can use NewTrasdata