BMW M2 SERIES F87 3.0L L6 24V CSL 331kW/444HP MEVD17.2.G

ECU BOSCH MEVD17.2.G · 450 CV (331 kW) · 3000 cc · Benzina sovralimentato

ECU-databaseBMW › BMW M2 SERIES F87 3.0L L6 24V CSL 331kW/444HP MEVD17.2.G

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 3 firmwareversies

Voertuiggegevens

MerkBMW
ModelM2 SERIES F87
Motor3.0L L6 24V CSL 331kW/444HP MEVD17.2.G
Standaard vermogen450 CV / 331 kW
Cilinderinhoud3000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMEVD17.2.G
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Base timing
  • Base timing 2
  • Optimal spark timing/MBT
  • Boost pressure
  • Boost pressure 2
  • Desired engine load calculation
  • Compression ratio for turbocharger protection
  • HFM/HLM threshold for diagnosis
  • Intake valve lift
  • Intake valve lift - full load
  • Torque limiter 2
  • Torque limiter 3
  • Torque limiter 4
  • Torque limiter 5
  • Torque limiter 6
  • Basic value setpoint Lambda sensor
  • Lambda target value
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Speed limiter 3
  • Speed limiter 4
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Driver torque request Normal mode - AT
  • Driver torque request Sport mode - AT

Firmware-identificatoren (3)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
00001A830A3B0200001A841D2D02 1.98.00200004A231D2D81 BOSCH MEVD17.2.G
00005BA60B130200005BA8135001 1.94.00400005AB613502A BOSCH MEVD17.2.G
00005BA60B130200005BA8135A01 1.94.0070000719B135A40 BOSCH MEVD17.2.G

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop