AUDI S5 (B9) 3.0L V6 24V TFSI 260kW/348HP MG1CS002

ECU BOSCH MG1CS002 · 354 CV (26 kW) · 3000 cc · Benzina sovralimentato

ECU-databaseAUDI › AUDI S5 (B9) 3.0L V6 24V TFSI 260kW/348HP MG1CS002

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 12 firmwareversies

Voertuiggegevens

MerkAUDI
ModelS5 (B9)
Motor3.0L V6 24V TFSI 260kW/348HP MG1CS002
Standaard vermogen354 CV / 26 kW
Cilinderinhoud3000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMG1CS002
Geheugen / EPROMMicro BGA FREESCALE - 8192 Kbit - 800000

Beschikbare tuning-opties:

  • Maximum air charge for overboost protection with turbocharger fault 2
  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Optimal spark timing/MBT 2
  • Boost pressure limiter 2
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Maximum torque limitation at clutch 2
  • Compression ratio for turbocharger protection
  • Compression ratio limiting for compressor depending on IAT sensor
  • Max accepted exhaust gas temperature at exhaust manifold
  • Exhaust gas temperature
  • Maximum exhaust gas temperature GPF in regeneration mode for component protection
  • Exhaust valves lift
  • Filling factor limit
  • Filling factor limit 2
  • Factor for reducing maximum filling
  • Engine torque reducing factor depending on temperature
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Intake valve lift
  • L
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda minimum value for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Engine speed limit temperature based
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Maximum intake manifold pressure
  • Maximum throttle angle opening for a given RPM
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • Specific air mass charge - correction
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Throttle angle management
  • Target Lambda for knock protection
  • Torque limiter in recovery mode
  • Torque limiter in recovery mode 2
  • Torque limiter in recovery mode 3
  • Torque limiter in recovery mode 4
  • Torque limiter in recovery mode 6
  • Turbocharger volumetric efficiency

Firmware-identificatoren (12)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.02.0048W0907559H 0009 BOSCH MG1CS002
1.00.0108W0907559G 0009 BOSCH MG1CS002
1.02.0088W0907559G 0010 BOSCH MG1CS002
1.00.0058W0907559N 0002 BOSCH MG1CS002
1.02.0168W0907559G 0008 BOSCH MG1CS002
1.02.0108W0907559H 0008 BOSCH MG1CS002
1.02.0088W0907559G 0007 BOSCH MG1CS002
1.02.0078W0907559L 0002 BOSCH MG1CS002
1.02.0038W0907559G 0011 BOSCH MG1CS002
1.02.02880A907559D 0002 BOSCH MG1CS002
1.02.00780A907559C 0005 BOSCH MG1CS002
1.02.0068W0907559H 0007 BOSCH MG1CS002

ECU-notities

Microprocessor BGA FREESCALE SPC57xxx This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata