Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.
✓ Tuning via bestand (flash)
1 firmwareversies
Voertuiggegevens
| Merk | AUDI |
| Model | S3 (8V) |
| Motor | 2.0L L4 16V TFSI 221kW/296HP SIMOS 12 |
| Standaard vermogen | 300 CV / 221 kW |
| Cilinderinhoud | 2000 cc |
| Brandstof | Benzina sovralimentato |
| Voertuigtype | Auto |
ECU
| Fabrikant | CONTINENTAL-SIEMENS-VDO |
| Model | SIMOS 12.x |
| Geheugen / EPROM | MICRO ST TRICORE - 32768 Kbit - 400000 |
Beschikbare tuning-opties:
- Base timing
- Base timing 2
- Lambda/AFR full load/WOT
- Advance correction for IAT sensor
- Boost pressure limiter
- Desired engine load calculation - high port flap position
- Desired engine load calculation - low port flap position
- Lambda correction
- Maximum torque limitation at clutch
- Gearbox maximum torque allowed
- High pressure fuel pump setpoint
- Intake pressure protection
- Torque limiter
- RPM Limiter
- Lambda reference
- Knock detection factor
- Max torque profile for gearbox protection - AT
- Max torque profile for gearbox protection - MT
- Max torque profile - AT
- Max torque profile - MT
- Optimal engine moment
- Engine moment management - high port flap position
- Engine moment management - low port flap position
- Maximum pressure ratio limit depending on temperature
- Pop/blow off valve offset - close model
- Pop/blow off valve offset - open model
- Driver torque request
- Driver torque request for high speed
- Driver torque request for high speed - MT
- Driver torque request for high speed in Sport mode
- Driver torque request for low speed
- Driver torque request for low speed - MT
- Driver torque request for low speed in Sport mode
- Driver torque request for reverse gear
Firmware-identificatoren (1)
| Hardware-nr. | Software-nr. (chip) | Versie | Update-software | ECU |
|---|
| — | — |
1.33.048 | 8V0906259 0006 |
CONTINENTAL-SIEMENS-VDO SIMOS 12.x |
Technische voertuignotities
OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.
ECU-notities
MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Verkrijg het bestand voor dit voertuig
Tools om deze ECU te lezen en schrijven
