AUDI RSQ3 (8U) 2.5L 20V TFSI 228kW/306HP MED17.1.6

ECU BOSCH MED17.1.6 · 310 CV (228 kW) · 2500 cc · Benzina sovralimentato

ECU-databaseAUDI › AUDI RSQ3 (8U) 2.5L 20V TFSI 228kW/306HP MED17.1.6

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 3 firmwareversies

Voertuiggegevens

MerkAUDI
ModelRSQ3 (8U)
Motor2.5L 20V TFSI 228kW/306HP MED17.1.6
Standaard vermogen310 CV / 228 kW
Cilinderinhoud2500 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMED17.1.6
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Height correction for boost pressure
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio limiting for compressor depending on IAT sensor
  • Desired pressure ratio
  • Exhaust gas temperature
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • L
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • Boost pressure linearization
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Speed limiter 3
  • Maximum indicated torque
  • Maximum indicated torque (overboost active)
  • Maximum boost pressure load
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Constant pressure control
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation 2
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Driver torque request 2
  • Torque limiter for selected gear
  • Throttle angle management

Firmware-identificatoren (3)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.00.0148U0907404A 0003 BOSCH MED17.1.6
1.00.0358U0907404A 0004 BOSCH MED17.1.6
1.00.0078U0907404A 0005 BOSCH MED17.1.6

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop