AUDI R8 (42) MY12 5.2L V10 FSI GT 412kW/553HP MED9.1/5

ECU BOSCH MED9.1.1/MED9.1.2 · 560 CV (412 kW) · 5200 cc · Benzina aspirato

ECU-databaseAUDI › AUDI R8 (42) MY12 5.2L V10 FSI GT 412kW/553HP MED9.1/5

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 2 firmwareversies

Voertuiggegevens

MerkAUDI
ModelR8 (42) MY12
Motor5.2L V10 FSI GT 412kW/553HP MED9.1/5
Standaard vermogen560 CV / 412 kW
Cilinderinhoud5200 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMED9.1.1/MED9.1.2
Geheugen / EPROMMICRO BGA+FLASH ESTERNA

Beschikbare tuning-opties:

  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Injection at part load
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Relative permissible torque from the pedal position in torque limitation
  • Driver torque request
  • Throttle angle management

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
0261S028231037516444 1.00.02242B910552 0010 BOSCH MED9.1.1/MED9.1.2
0261S028671037521124 1.00.00742B910552 0010 BOSCH MED9.1.1/MED9.1.2

Technische voertuignotities

OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.

ECU-notities

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop