AUDI A6 (C4/4A) 4.2L V8 40V 253KW/344HP ME7.1.1

ECU BOSCH ME7.1.1 · 344 CV (253 kW) · 4200 cc · Benzina aspirato

ECU-databaseAUDI › AUDI A6 (C4/4A) 4.2L V8 40V 253KW/344HP ME7.1.1

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 8 firmwareversies

Voertuiggegevens

MerkAUDI
ModelA6 (C4/4A)
Motor4.2L V8 40V 253KW/344HP ME7.1.1
Standaard vermogen344 CV / 253 kW
Cilinderinhoud4200 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME7.1.1
Geheugen / EPROM29F800 PSOP44 8Mbit - Flash 512K x 16

Beschikbare tuning-opties:

  • Advance at part load
  • Load / throttle position reference
  • Injection at part load
  • Advance limiter
  • Torque limiter
  • Lambda enrichment for components protection
  • Knock detection factor
  • Load/throttle position reference - AT
  • Air mass flow

Firmware-identificatoren (8)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
02612068421037354729 1.21.0124D0907558R 0001 BOSCH ME7.1.1
02612068431037354728 1.21.0064D0907560AE 0001 BOSCH ME7.1.1
02612070421037354529 1.21.0054D0907560AR 0001 BOSCH ME7.1.1
02612075401037362906 1.21.0064D0907560CE 0002 BOSCH ME7.1.1
02612076301037362395 1.21.0134D0907558AD 0001 BOSCH ME7.1.1
02612076301037362912 1.21.0054D0907558AD 0002 BOSCH ME7.1.1
02612083631037370690 1.42.0184F0910560 0030 BOSCH ME7.1.1
02612084441037372809 1.42.0038E0910560L 0010 BOSCH ME7.1.1

ECU-notities

Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! This Setting File can be used for serial system NewGenius. Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator.