AUDI A4 (B7/8E/8H) 2.7L V6 24V TDI 132KW/177HP EDC16U31/CP34

ECU BOSCH EDC16U31/U34/CP34 · 179 CV (132 kW) · 2700 cc · Diesel sovralimentato

ECU-databaseAUDI › AUDI A4 (B7/8E/8H) 2.7L V6 24V TDI 132KW/177HP EDC16U31/CP34

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 13 firmwareversies

Voertuiggegevens

MerkAUDI
ModelA4 (B7/8E/8H)
Motor2.7L V6 24V TDI 132KW/177HP EDC16U31/CP34
Standaard vermogen179 CV / 132 kW
Cilinderinhoud2700 cc
BrandstofDiesel sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelEDC16U31/U34/CP34
Geheugen / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Beschikbare tuning-opties:

  • Boost pressure limiter
  • Maximum engine boost pressure F (atmospheric pressure)
  • Boost pressure
  • Boost pressure 2
  • Maximum torque limitation at clutch
  • Load / throttle position reference
  • EGR valve control
  • Exhaust gas temperature
  • Protection for engine overheating
  • Basic torque management at engine cranking
  • Engine idle vs. ECT sensor
  • Injection period
  • Injection period - correction
  • Injection opening time related to inj. pressure
  • J
  • Torque limiter 2
  • Lambda value of the smoke limitation
  • Minimum LSU sensor temperature for O2
  • Maximum LSU sensor temperature for O2
  • LSU temperature threshold PID heater governor activation
  • Protection for air load overheating
  • Protection for fuel overheating
  • Protection for oil overheating
  • Specific injection pressure limiter
  • Specific injection pressure
  • Q
  • Driver torque request
  • Torque limiter for the 1st gear selected
  • Torque limiter for the 2nd gear selected
  • Torque limiter for the 3rd gear selected
  • Torque limiter for the 4th gear selected
  • Torque limiter for the 5th gear selected
  • Torque limiter for the 6th gear selected
  • Torque limiter for for reverse gear
  • Torque limiter for the APS/BPS
  • Torque limiter in recovery mode
  • Turbocharger volumetric efficiency
  • Variable geometry duty cycle limit

Firmware-identificatoren (13)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1037383861 1.67.0118E2910401N 0040 BOSCH EDC16U31/U34/CP34
1037382076 1.67.0148E2910401D 0060 BOSCH EDC16U31/U34/CP34
1037391559 1.67.0228E2910401J 0050 BOSCH EDC16U31/U34/CP34
1037383856 1.67.0138E2910401J 0040 BOSCH EDC16U31/U34/CP34
1037379733 1.67.0338E2910401D 0040 BOSCH EDC16U31/U34/CP34
1037382700 1.67.0138E2910401R 0020 BOSCH EDC16U31/U34/CP34
1037380781 1.67.0268E2910401D 0050 BOSCH EDC16U31/U34/CP34
1037384614 1.67.0148E2ABT401P A030 BOSCH EDC16U31/U34/CP34
1037391560 1.67.0228H1910401 0050 BOSCH EDC16U31/U34/CP34
1037383855 1.67.0358H1910401 0040 BOSCH EDC16U31/U34/CP34
1037382699 1.67.0138E2910401P 0020 BOSCH EDC16U31/U34/CP34
1037391549 1.67.0228E2910401E 0050 BOSCH EDC16U31/U34/CP34
1037383852 1.67.0268E2910401E 0040 BOSCH EDC16U31/U34/CP34

Technische voertuignotities

OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.

ECU-notities

Original EPROM Am29BDD160G PQFP 80 Pin - Microprocessor Motorola MPC56x. This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata
Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This Setting File can be used for serial system NewGenius. To modify this Ecu you can use the BDM system:555PRO or TRASDATA. WARNING:TRASDATA DO NOT need additional tools, 555PRO instead requires recalculation chks with VAG EDC16 CHECKSUM tool supplied with 555PRO, otherwise you will cause the block of the ecu or the detection of a change in the Ecu through diagnostic tool.

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop