Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.
✓ Tuning via bestand (flash)
4 firmwareversies
Voertuiggegevens
| Merk | AUDI |
| Model | A4 (B6/8E/8H) |
| Motor | 3.0L V6 24V 160kW/215HP ME7.1.1 |
| Standaard vermogen | 218 CV / 16 kW |
| Cilinderinhoud | 3000 cc |
| Brandstof | Benzina aspirato |
| Voertuigtype | Auto |
ECU
| Fabrikant | BOSCH |
| Model | ME7.1.1 |
| Geheugen / EPROM | 29F800 PSOP44 8Mbit - Flash 512K x 16 |
Beschikbare tuning-opties:
- Base timing
- Optimal spark timing/MBT
- Desired engine load calculation
- Lambda correction for engine temperature after starting
- Exhaust gas temperature
- Torque limiter for diagnostic
- Lambda enrichment for components protection
- RPM Limiter
- RPM Limiter 2
- Lambda driver wish
- Knock detection factor
- Throttle air mass flow calculation
- Optimal engine moment
- Offset tolerance depending on permissible torque
- Relative permissible torque from the pedal position in torque limitation
- Driver torque request
- Throttle angle management
Firmware-identificatoren (4)
| Hardware-nr. | Software-nr. (chip) | Versie | Update-software | ECU |
|---|
| 0261201168 | 1037376340 |
1.21.005 | 8E0909059B P0000 |
BOSCH ME7.1.1 |
| 0261208346 | 1037367738 |
1.21.008 | 8E0909559R 0010 |
BOSCH ME7.1.1 |
| 0261208559 | 1037371758 |
1.21.012 | 8E1909559B 0030 |
BOSCH ME7.1.1 |
| 0261208851 | 1037372815 |
1.21.009 | 8E1909559D 0010 |
BOSCH ME7.1.1 |
Technische voertuignotities
OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.
ECU-notities
Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! This Setting File can be used for serial system NewGenius. Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator.
Verkrijg het bestand voor dit voertuig
Tools om deze ECU te lezen en schrijven
