Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.
✓ Tuning via bestand (flash)
✓ Aanvullende module beschikbaar 12 firmwareversies
Voertuiggegevens
| Merk | AUDI |
| Model | A3 (8V) |
| Motor | 2.0L L4 16V TDI 110kW/148HP EDC17C74 |
| Standaard vermogen | 150 CV / 11 kW |
| Cilinderinhoud | 2000 cc |
| Brandstof | Diesel sovralimentato |
| Voertuigtype | Auto |
ECU
| Fabrikant | BOSCH |
| Model | EDC17C74 |
| Geheugen / EPROM | MICRO ST TRICORE - 32768 - 400000 |
Beschikbare tuning-opties:
- Boost pressure limiter
- Boost pressure limiter 2
- Boost limiter correction for APS/BPS sensor
- Boost pressure limiter for ECT sensor
- Protection for cylinder head overheating
- Engine load - ceiling
- Maximum torque limitation at clutch
- Regeneration limit for DPF
- EGR valve control
- EGR valve control 2
- Max accepted exhaust gas temperature value before turbine
- Max accepted exhaust gas temperature value before turbine 2
- Protection for engine overheating
- Protection for engine overheating 2
- Basic torque management at engine cranking
- Injection period
- Injection period 2
- Injection period 3
- Injection period 4
- Injection period 5
- Injection period 6
- Injection period 7
- Injection period 8
- Injection period - correction
- Maximum injection period
- Injection opening time related to inj. pressure
- Initialization values over pressure control valve
- Injection 1
- Injection 2
- Boost pressure deviation limits for overboost detection
- Boost pressure deviation limit for underboost detection
- Boost pressure deviation limit for underboost detection 2
- Torque limiter
- Smoke limiter
- Lambda value of the smoke limitation
- Lambda value of the smoke limitation 2
- Speed limiter
- Speed limiter 2
- Maximum indicated torque for monitoring
- Maximum engine torque at crank shaft
- Protection for air load overheating
- Protection for exhaust gas temperature before turbine
- Protection for exhaust gas temperature before turbine 2
- Protection for fuel overheating
- Protection for fuel overheating 2
- Protection for oil overheating
- Pressure control map over pressure regulating valve
- Specific injection pressure limiter
- Specific injection pressure limiter for EFT sensor
- Specific injection pressure limiter for EFT sensor 2
- Relative permissible torque from the pedal position in torque limitation
- Maximum pressure ratio limit depending on temperature
- Specific injection pressure
- Specific injection pressure 2
- Specific injection pressure 3
- Specific injection pressure 4
- Specific air mass charge 2
- Specific air mass charge 3
- Specific air mass charge 4
- Air mass flow
- Driver torque request
- Driver torque request for reverse gear
- CAT downstream temperature sensor characterization
- CAT upstream temperature sensor characterization
- DPF downstream temperature sensor characterization
- Turbo upstream temperature sensor characterization
- Setpoint maximum turbocharger speed
- Overboost timing
- Overboost timing 2
- Overboost timing 3
- Overboost timing 4
- Turbocharger volumetric efficiency
Firmware-identificatoren (12)
| Hardware-nr. | Software-nr. (chip) | Versie | Update-software | ECU |
|---|
| — | — |
1.94.003 | 04L906027AG 9970 |
BOSCH EDC17C74 |
| — | — |
1.94.004 | 04L906026BN 7759 |
BOSCH EDC17C74 |
| — | — |
1.94.009 | 04L906026BP 7608 |
BOSCH EDC17C74 |
| — | — |
1.94.018 | 04L906027S 6818 |
BOSCH EDC17C74 |
| — | — |
1.94.013 | 04L906026BN 1197 |
BOSCH EDC17C74 |
| — | — |
1.94.012 | 04L906026BQ 1199 |
BOSCH EDC17C74 |
| — | — |
1.94.018 | 04L906026HB 3052 |
BOSCH EDC17C74 |
| — | — |
1.94.011 | 04L906026NF 6380 |
BOSCH EDC17C74 |
| — | — |
1.94.013 | 04L906026BP 1198 |
BOSCH EDC17C74 |
| — | — |
1.94.015 | 04L906027AG 9530 |
BOSCH EDC17C74 |
| — | — |
1.94.013 | 04L906026RJ 4381 |
BOSCH EDC17C74 |
| — | — |
1.94.001 | 04L906026BN 7607 |
BOSCH EDC17C74 |
Technische voertuignotities
OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.
ECU-notities
MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Verkrijg het bestand voor dit voertuig
Tools om deze ECU te lezen en schrijven
