AUDI A3 (8V) 1.4L L4 16V TSI 110kW/148HP MED17.1.27

ECU BOSCH MED17.1.27 · 150 CV (11 kW) · 1400 cc · Benzina sovralimentato

ECU-databaseAUDI › AUDI A3 (8V) 1.4L L4 16V TSI 110kW/148HP MED17.1.27

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 4 firmwareversies

Voertuiggegevens

MerkAUDI
ModelA3 (8V)
Motor1.4L L4 16V TSI 110kW/148HP MED17.1.27
Standaard vermogen150 CV / 11 kW
Cilinderinhoud1400 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMED17.1.27
Geheugen / EPROMMICRO ST TRICORE - 32768 - 400000

Beschikbare tuning-opties:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Optimal spark timing/MBT
  • Boost pressure limiter
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor for reducing maximum filling
  • Gearbox maximum torque allowed
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Knock detection factor
  • Speed limiter
  • Maximum compression ratio
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • % relative air filling limit depending on IAT
  • Throttle angle management

Firmware-identificatoren (4)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.94.00204E906024CJ 2868 BOSCH MED17.1.27
1.94.00904E906025AB 7355 BOSCH MED17.1.27
1.94.00804E906025AA 7350 BOSCH MED17.1.27
1.94.00204E906024F 9821 BOSCH MED17.1.27

ECU-notities

MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata