Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.
✓ Tuning via bestand (flash)
1 firmwareversies
Voertuiggegevens
| Merk | ALFA ROMEO |
| Model | MiTo |
| Motor | 1.4L 16V TB Multiair 125kW/168HP IAW8GF |
| Standaard vermogen | 170 CV / 125 kW |
| Cilinderinhoud | 1400 cc |
| Brandstof | Benzina sovralimentato |
| Voertuigtype | Auto |
ECU
| Fabrikant | MARELLI |
| Model | 8GMK/8GML |
| Geheugen / EPROM | Micro BGA STSPC564A80 - 32748Kbit - 400000 |
Beschikbare tuning-opties:
- Optimal spark timing/MBT
- Spark advance correction for ECT sensor
- Advance correction for IAT sensor
- Base lambda - cold
- Base Lambda - hot
- Boost pressure limiter
- Electronic throttle control
- Compressor pressure ratio limit for pumping and speed
- Average power effective limitation
- Average torque effective limitation
- Torque limiter
- Maximum Upstream pressure in event of Normal boost modality
- Maximum Upstream pressure in event of normal boost modality, Offroad mode activated
- Maximum Upstream pressure in event of normal boost modality, Sport mode activated
- Maximum Upstream pressure in event of overboost modality
- Maximum Upstream pressure in event of overboost modality, Offroad modality activated
- Maximum Upstream pressure in event of overboost modality, Sport modality activated
- Max torque profile
- Torque management in Normal mode
- Torque management in Offroad mode
- Torque management Sport mode
- Power Control in Normal mode
- Power Control in Sport mode
- Power limit torque table
- Resistant torque table
- Torque limit table for ECT sensor
- Take-off torque law in Normal mode with power control
- Take-off torque law in Sport mode
- Take-off torque law in Sport mode with power control
- Wastegate duty-cycle
Firmware-identificatoren (1)
| Hardware-nr. | Software-nr. (chip) | Versie | Update-software | ECU |
|---|
| MM8GMKHW651 | K540PA65 |
1.91.008 | K540PA65 |
MARELLI 8GMK/8GML |
Technische voertuignotities
ECU located on or behind the engine block. It may be necessary to remove the engine cover. Difficulty: easy.
OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.
ECU-notities
Microprocessor BGA SPC564A80 This Setting File can be used for serial system NewGenius. ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual. To work on this ECU you can use NewTrasdata
Verkrijg het bestand voor dit voertuig
Tools om deze ECU te lezen en schrijven
