ALFA ROMEO MiTo 1.4L 16V TB 115kW/155HP IAW8GMF

ECU MARELLI 8GF · 156 CV (115 kW) · 1400 cc · Benzina sovralimentato

ECU-databaseALFA ROMEO › ALFA ROMEO MiTo 1.4L 16V TB 115kW/155HP IAW8GMF

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkALFA ROMEO
ModelMiTo
Motor1.4L 16V TB 115kW/155HP IAW8GMF
Standaard vermogen156 CV / 115 kW
Cilinderinhoud1400 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantMARELLI
Model8GF
Geheugen / EPROMMICRO BGA MOTOROLA FRESCALE con FLASH interna 12288 Kbit - 0x180000

Beschikbare tuning-opties:

  • Optimal spark timing/MBT
  • Advance at part load
  • Advance correction
  • Base lambda - cold
  • Base Lambda - hot
  • Boost pressure limiter
  • Electronic throttle control
  • Compressor pressure ratio limit for pumping and speed
  • Average power effective limitation
  • Average torque effective limitation
  • Advance limiter
  • Basic value setpoint Lambda sensor
  • RPM Limiter
  • Maximum Upstream pressure in event of Normal boost modality
  • Maximum Upstream pressure in event of normal boost modality, Sport mode activated
  • Maximum Upstream pressure in event of overboost modality
  • Maximum Upstream pressure in event of overboost modality, Sport modality activated
  • Max torque profile
  • Torque management in Normal mode
  • Torque management Sport mode
  • Power Control in Normal mode
  • Power Control in Sport mode
  • Power limit torque table
  • Resistant torque table
  • Torque limit table for ECT sensor
  • Take-off torque law in Normal mode
  • Take-off torque law in Normal mode with power control
  • Take-off torque law in Sport mode
  • Take-off torque law in Sport mode with power control
  • Wastegate duty-cycle

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
MM8GMFHW5021L20CA36 1.91.014 MARELLI 8GF

ECU-notities

Microprocessor FMPC5553 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual.