Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.
✓ Tuning via bestand (flash)
3 firmwareversies
Voertuiggegevens
| Merk | ALFA ROMEO |
| Model | MiTo |
| Motor | 1.4L 16V Multiair 77kW/104HP IAW8GF |
| Standaard vermogen | 105 CV / 77 kW |
| Cilinderinhoud | 1400 cc |
| Brandstof | Benzina sovralimentato |
| Voertuigtype | Auto |
ECU
| Fabrikant | MARELLI |
| Model | 8GF |
| Geheugen / EPROM | MICRO BGA MOTOROLA FRESCALE con FLASH interna 12288 Kbit - 0x180000 |
Beschikbare tuning-opties:
- Optimal spark timing/MBT
- Advance at part load
- Advance correction
- Base lambda - cold
- Base Lambda - hot
- Boost pressure limiter
- Electronic throttle control
- Compressor pressure ratio limit for pumping and speed
- Average power effective limitation
- Average torque effective limitation
- Advance limiter
- Basic value setpoint Lambda sensor
- RPM Limiter
- Maximum Upstream pressure in event of Normal boost modality
- Maximum Upstream pressure in event of normal boost modality, Sport mode activated
- Maximum Upstream pressure in event of overboost modality
- Maximum Upstream pressure in event of overboost modality, Sport modality activated
- Max torque profile
- Torque management in Normal mode
- Torque management Sport mode
- Power Control in Normal mode
- Power Control in Sport mode
- Power limit torque table
- Resistant torque table
- Torque limit table for ECT sensor
- Take-off torque law in Normal mode
- Take-off torque law in Normal mode with power control
- Take-off torque law in Sport mode
- Take-off torque law in Sport mode with power control
- Wastegate duty-cycle
Firmware-identificatoren (3)
| Hardware-nr. | Software-nr. (chip) | Versie | Update-software | ECU |
|---|
| MM8GMFHW502 | 1M10AA38 |
1.91.010 | — |
MARELLI 8GF |
| MM8GMFHW502 | 1M10AA39 |
1.91.009 | — |
MARELLI 8GF |
| MM8GMFHW502 | 1N00AA42 |
1.91.004 | — |
MARELLI 8GF |
Technische voertuignotities
OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.
ECU located on or behind the engine block. It may be necessary to remove the engine cover. Difficulty: easy.
ECU-notities
Microprocessor FMPC5553 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual.
Verkrijg het bestand voor dit voertuig
Tools om deze ECU te lezen en schrijven
