ALFA ROMEO MiTo 0.9L 8V TWINAIR TURBO 77kW/103HP IAW8GMF

ECU MARELLI 8GSW · 105 CV (77 kW) · 900 cc · Benzina sovralimentato

ECU-databaseALFA ROMEO › ALFA ROMEO MiTo 0.9L 8V TWINAIR TURBO 77kW/103HP IAW8GMF

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 2 firmwareversies

Voertuiggegevens

MerkALFA ROMEO
ModelMiTo
Motor0.9L 8V TWINAIR TURBO 77kW/103HP IAW8GMF
Standaard vermogen105 CV / 77 kW
Cilinderinhoud900 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantMARELLI
Model8GSW
Geheugen / EPROMMICRO BGA MOTOROLA FRESCALE con Flash interna MPC5565 16384 Kbit - 0x200000

Beschikbare tuning-opties:

  • Spark advance during acceleration
  • Advance at part load
  • Advance correction
  • Base lambda - cold
  • Base Lambda - hot
  • Boost pressure limiter
  • Electronic throttle control
  • Compressor pressure ratio limit for pumping and speed
  • Average power effective limitation
  • Average torque effective limitation
  • Advance limiter
  • Basic value setpoint Lambda sensor
  • Maximum Upstream pressure in event of Normal boost modality
  • Maximum Upstream pressure in event of normal boost modality, Sport mode activated
  • Maximum Upstream pressure in event of overboost modality
  • Maximum Upstream pressure in event of overboost modality, Sport modality activated
  • Max torque profile
  • Torque management Sport mode
  • Power Control in Normal mode
  • Power Control in Sport mode
  • Resistant torque table
  • Take-off torque law in Normal mode
  • Take-off torque law in Normal mode with power control
  • Take-off torque law in Sport mode
  • Take-off torque law in Sport mode with power control
  • Wastegate duty-cycle

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
MM8GSWHW607D3D1FA60 1.01.016 MARELLI 8GSW
MM8GSWHW608D432FA0C 1.91.005 MARELLI 8GSW

Technische voertuignotities

ECU located on or behind the engine block. It may be necessary to remove the engine cover. Difficulty: easy.
OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.

ECU-notities

Microprocessor FMPC 5565 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual.

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop