ABARTH GRANDE PUNTO 1.4L 16V TJET SS 132kW/178HP ME7.9.10

ECU BOSCH ME7.9.10 · 180 CV (132 kW) · 1400 cc · Benzina sovralimentato

ECU-databaseABARTH › ABARTH GRANDE PUNTO 1.4L 16V TJET SS 132kW/178HP ME7.9.10

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 3 firmwareversies

Voertuiggegevens

MerkABARTH
ModelGRANDE PUNTO
Motor1.4L 16V TJET SS 132kW/178HP ME7.9.10
Standaard vermogen180 CV / 132 kW
Cilinderinhoud1400 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME7.9.10
Geheugen / EPROMMICRO ST - 6656 Kbit

Beschikbare tuning-opties:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Optimal spark timing/MBT
  • Spark advance correction for ECT sensor
  • Boost pressure limiter 3
  • Boost pressure limiter 4
  • Boost pressure limiter 5
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio for turbocharger protection
  • Desired pressure ratio
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • Lambda enrichment for components protection
  • RPM Limiter
  • RPM Limiter 2
  • RPM limit for EOT sensor
  • Lambda driver wish
  • Knock detection factor
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Max torque profile
  • Optimal engine moment
  • Boost pressure threshold cycles for the overboost recognition
  • Power limit torque table
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Turbocharger volumetric efficiency
  • Wastegate duty-cycle

Firmware-identificatoren (3)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
02612016651037397663 1.91.008 BOSCH ME7.9.10
02612016851037398569 1.91.030 BOSCH ME7.9.10
0261S046621037400604 1.91.040 BOSCH ME7.9.10

Technische voertuignotities

OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.

ECU-notities

Microprocessor ST10F275 This Setting File can be used for serial system : Genius or NewGenius. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop