TOYOTA TACOMA (N220/N240/N250/N260/N270) 4.0L V6 VVT-i TRD 228kW/306HP DENSO

ECU DENSO 275036-5130 · 310 CV (228 kW) · 4000 cc · Benzina sovralimentato

ECU-databaseTOYOTA › TOYOTA TACOMA (N220/N240/N250/N260/N270) 4.0L V6 VVT-i TRD 228kW/306HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelTACOMA (N220/N240/N250/N260/N270)
Motor4.0L V6 VVT-i TRD 228kW/306HP DENSO
Standaard vermogen310 CV / 228 kW
Cilinderinhoud4000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-5130
Geheugen / EPROMMICRO NEC 76F0070 - 8192 Kbit - 100000

Beschikbare tuning-opties:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 3

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-YWG41- 1.67.0073YWG4100 DENSO 275036-5130
89663-YWG38- 1.67.0153YWG3800 DENSO 275036-5130

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

Microprocessor NEC 76F0070 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata