TOYOTA LAND CRUISER PRADO (J150) 3.5L V6 24V VVT-i 207kW/278HP DENSO

ECU DENSO D76F0196F1 · 281 CV (207 kW) · 3500 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA LAND CRUISER PRADO (J150) 3.5L V6 24V VVT-i 207kW/278HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelLAND CRUISER PRADO (J150)
Motor3.5L V6 24V VVT-i 207kW/278HP DENSO
Standaard vermogen281 CV / 207 kW
Cilinderinhoud3500 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
ModelD76F0196F1
Geheugen / EPROMMIcro NEC D76F0196F1 - 1536 Kbit - 180000

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Lambda correction f(ECT) 3
  • Injection opening time related to inj. pressure
  • Injection opening time related to inj. pressure 2
  • Injection opening time related to inj. pressure 3
  • Advance limiter
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • Specific injection pressure
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Throttle angle management
  • Throttle angle management 2
  • Torque limit table for ECT sensor
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-0G011- 1.67.00630G01100 DENSO D76F0196F1
89663-0G040- 1.67.00930G04000 DENSO D76F0196F1

ECU-notities

Microprocessor D76F0196F1 This Setting File can be used for serial system NewGenius.