TOYOTA LAND CRUISER PRADO (J120) 2.7L 16V VVT-i 120kW/161HP DENSO

ECU DENSO 275036-6941 · 163 CV (12 kW) · 2700 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA LAND CRUISER PRADO (J120) 2.7L 16V VVT-i 120kW/161HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 5 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelLAND CRUISER PRADO (J120)
Motor2.7L 16V VVT-i 120kW/161HP DENSO
Standaard vermogen163 CV / 12 kW
Cilinderinhoud2700 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-6941
Geheugen / EPROMMICRO NEC 76F0039GD - 512 Kbit - 80000

Beschikbare tuning-opties:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Lambda driver wish 2
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 2
  • Variable valve timing - inlet

Firmware-identificatoren (5)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-60750- 1.67.00936075000 DENSO 275036-6941
89663-0KJ30- 1.51.00630KJ3000 DENSO 275036-9170
89663-0K630- 1.67.00930K63000 DENSO 275036-9170
89663-0KX30- 1.67.01430KX3000 DENSO 275036-9170
89663-0K650- 1.51.00430K65000 DENSO 275036-9170

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor NEC 76F0040GD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata