TOYOTA HIGHLANDER/KLUGER (XU40) 3.5L 24V V6 201kW/270HP DENSO

ECU DENSO 275036-2110 · 273 CV (201 kW) · 3500 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA HIGHLANDER/KLUGER (XU40) 3.5L 24V V6 201kW/270HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelHIGHLANDER/KLUGER (XU40)
Motor3.5L 24V V6 201kW/270HP DENSO
Standaard vermogen273 CV / 201 kW
Cilinderinhoud3500 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-2110
Geheugen / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Beschikbare tuning-opties:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Lambda correction f(ECT) 3
  • Gearbox maximum torque allowed
  • Advance limiter for component protection 1
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-33341- 1.51.00933334100 DENSO 275036-2110

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata