TOYOTA BLADE (E150) 2.4L 16V VVT-i 123kW/165HP DENSO

ECU DENSO 275036-1152 · 167 CV (123 kW) · 2400 cc · Benzina aspirato

ECU-databaseTOYOTA › TOYOTA BLADE (E150) 2.4L 16V VVT-i 123kW/165HP DENSO

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkTOYOTA
ModelBLADE (E150)
Motor2.4L 16V VVT-i 123kW/165HP DENSO
Standaard vermogen167 CV / 123 kW
Cilinderinhoud2400 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantDENSO
Model275036-1152
Geheugen / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Beschikbare tuning-opties:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
89663-12362- 1.67.02331236200 DENSO 275036-1152
89663-28342- 1.67.00832834200 DENSO 275036-1152

Technische voertuignotities

OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.

ECU-notities

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata